show hyper_metro_consistency_group config
Function
Parameters
Parameter |
Description |
Value |
|---|---|---|
| consistency_group_id=? | ID of the HyperMetro consistency group. | Run the "show hyper_metro_consistency_group general" command without parameters to obtain the value. |
Example
View the memory information about the HyperMetro consistency group "3231333731308000".
developer:/>show hyper_metro_consistency_group config consistency_group_id=3231333731308000 Cg Used: TRUE Local Cg ID : 0 Remote Cg ID : 0 PairCopyDone : 0 PairNumber : 2 MngConStatus : 1 LinkStatus : 1 HealBit : 0 LockInfo : 0xffff88025aacc168 IsMaster : TRUE ID : 0x3231333731308000 Domain ID : 0x200bc79fabc80100 WorkMode : 1 IsPriority : TRUE UpdateSpeed : 1 RecoverPolicy : 1 ArbId : 0X200bc79fabc80000 ArbState : 1 Health Status : 0 ObjsType : 0 Name : CG1 Description : CG1 Log CurCode : 255 Log TranFlag : 0 Log BlockFlag : 0
System Response
The following table describes the parameter meanings.
Parameter |
Meaning |
|---|---|
| Cg Used | Use flag of the HyperMetro consistency group. |
| Local Cg ID | Local ID of the HyperMetro consistency group. |
| Remote Cg ID | Remote ID of the HyperMetro consistency group. |
| PairCopyDone | Flag of pair copy completion of the HyperMetro consistency group. |
| PairNumber | Number of pairs. |
| MngConStatus | Management link status of the HyperMetro consistency group. |
| LinkStatus | Link status of the HyperMetro consistency group. |
| HealBit | Self-heal bit. |
| LockInfo | Lock information. |
| IsMaster | Flag of the primary or secondary device. |
| ID | ID of the HyperMetro consistency group. |
| Domain ID | ID of the HyperMetro domain. |
| WorkMode | Working mode. |
| IsPriority | Flag of the preferred site. |
| UpdateSpeed | Synchronization rate. |
| RecoverPolicy | Recovery policy. |
| ArbId | Arbitration ID. |
| ArbState | Arbitration status. |
| Health Status | Health status. |
| ObjsType | Object type. |
| Name | Name of the HyperMetro consistency group. |
| Description | Description. |
| Log CurCode | Code recoded in the log. |
| Log TranFlag | Log flag. |
| Log BlockFlag | Block flag. |
