Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
snap showaction
Function
The snap showaction command is used to check the ID of the snapshot on which configuration errors occurred or to check the execution details of a snapshot.
Parameters
Parameter |
Description |
Value |
|---|---|---|
| snapshotID | Snapshot ID. | The value ranges from 0 to n minus one. n indicates the maximum number of LUNs. |
| error | Error. | The value is an error character string. |
Example
-
To check the ID of the snapshot where configuration errors occurred, run the following command.
admin:/diagnose>snap showaction error Error Snapshot Ids: 1
-
To check the execution details of a snapshot task, run the following command.
admin:/diagnose>snap showaction 1 Snapshot Id:1 Time TaskID Action Result Interval ------------------------------------------------------------------------------ -- 2014-12-11 17:34:37 3 CREATE TASK OK 0 2014-12-11 17:34:37 3 SNAP_ACTION_LUN_ORIGIN_BIND INIT 0 2014-12-11 17:34:37 3 SNAP_ACTION_LUN_ORIGIN_BIND OK 0 2014-12-11 17:34:37 3 SNAP_ACTION_TP_RESTORE_ACTIVE OK 0 2014-12-11 17:34:37 3 SNAP_ACTION_LUN_CACHE_BIND OK 0 2014-12-11 17:34:37 3 SNAP_ACTION_LUN_SET_TP OK 0 2014-12-11 17:34:37 3 SNAP_ACTION_LUN_SET_RW OK 0 2014-12-11 17:34:37 3 SNAP_ACTION_LUN_CHANGE_RW OK 0 2014-12-11 17:34:37 3 SNAP_ACTION_ADD_PERF_OBJ OK 0 2014-12-11 17:34:37 3 SNAP_ACTION_TASK_OVER OK 0
Previous
