Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change hyper_metro_pair full_sync_cfg
Function
The change hyper_metro_pair full_sync_cfg command is used to fully synchronize configurations of a specific HyperMetro pair.
Parameters
Parameter |
Description |
Value |
---|---|---|
pair_id | HyperMetro pair ID. | Run the "show hyper_metro_pair general" command to obtain the value. |
partition_type | Type of a configuration synchronization partition. |
|
Example
Fully synchronize configurations of a specific HyperMetro pair whose pair ID is "200bc79b99520000" and partition type is "nfs_share".
developer:/>change hyper_metro_pair full_sync_cfg pair_id=200bc79b99520000 partition_type=nfs_share WARNING: You are going to start configuration full synchronization. Once configuration synchronization is started, remote configuration will be overwritten by local configuration. After configuration synhronization, the configuration cannot be restored. Suggestion: Before performing this operation, ensure that the parameters are configured correctly to prevent configuration loss. Have you read warning message carefully?(y/n)y Are you sure you really want to perform the operation?(y/n)y Command executed successfully.