Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
switch mode
Parameters
Parameter |
Description |
Value |
|---|---|---|
| mode | Mode. | The value can be 0 or 1, where:
|
Example
-
Set the switchover mode of serial ports to "manual" on a 6 U management board. The command output varies depending on a specific product.
administrator@SMM_6U / $ switch mode 1
-
Set the switchover mode of serial ports to "automatic" on a 6 U management board. The command output varies depending on a specific product.
administrator@SMM_6U / $ switch mode 0
-
Set the switchover mode of serial ports to "manual" on a 4 U controller board. The command output varies depending on a specific product.
iBMC:/->switch mode 1
-
Set the switchover mode of serial ports to "automatic" on a 4 U controller board. The command output varies depending on a specific product.
iBMC:/->switch mode 0
Previous
