Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change remote_replication link_status_enabled
Function
The change remote_replication link_status_enabled command is used to change the status of the management link on local end remote replication to OK.
Parameters
Parameter |
Description |
Value |
|---|---|---|
| remote_replication_id=? | Remote replication ID | To obtain the value, run the show remote_replication general command without parameters. |
Usage Guidelines
This command is used to change the status of the management link on local end remote replication to OK. You should run this command under the guidance of a maintenance engineer.
Previous
