No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 2800 V5 V500R007

This document is applicable to OceanStor 2800 V5. Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change remote_replication startup

change remote_replication startup


The change remote_replication startup command is used to forcibly change the local end of a remote replication pair to the primary end.


change remote_replication startup remote_replication_id=?





remote_replication_id=? ID of a remote replication task.

To obtain the value, run "show remote_replication general".


Developer view

Usage Guidelines

  • Use this command when the primary/secondary switchover of remote replication pairs fails due to an exception.
  • Use this command under the guidance of maintenance engineers.


Forcibly change the local end of remote replication consistency pair "9747215445131264" to the primary end.

developer:/>change remote_replication startup remote_replication_id=9747215445131264
DANGER: You are about to upgrade the local end to be the primary end of the remote replication pair. This operation forcibly upgrades the local end to be the primary end of the remote replication pair. The remote replication pair may have two primary ends. As a result, the remote replication pair becomes invalid.
Suggestion: Before performing this operation, ensure that the selected remote replication pair is correct and both ends of the remote replication pair are secondary ends.
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2020-01-17

Document ID: EDOC1000181575

Views: 719038

Downloads: 31

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next