cliset -d setpoweron
Function
Parameters
Parameter |
Description |
Value |
---|---|---|
parameter1 | Controller enclosure to be powered on. | The value is "1", indicating that the controller enclosure will be powered on. |
Usage Guidelines
After the entire controller enclosure is powered off, you can run the cliset -d setpoweron 1 command to power on it.
Example
-
Enter "cliset -d setpoweron 1" on the serial port interface of the management module. The command output varies depending on a specific product.
administrator@SMM_3U / $ cliset -d setpoweron 1 administrator@SMM_3U / $ BOARD 0 state changed,cause is 0 .......................p0->p1 set digital led value(888) Displayrule(1) Ok, SysPowerStatus:1, g_Opened:1. BOARD 0 state changed,cause is 0 .......................p1->p2 [ 375.798892] Begin to unregister USB platform device, Can't using USB now! [ 377.142419] set irq67 to cpu:0x1 [ 377.195690] In ohci_hcd_hi1710_drv_probe [ 377.199646] set irq68 to cpu:0x1 BOARD 0 state changed,cause is 0 .......................p2->p3.
-
Enter "cliset -d setpoweron 1" on the serial port interface. The command output varies depending on a specific product.
iBMC:/->cliset -d setpoweron 1 BOARD CTRL 0 state changed.......................p0->p1 BOARD CTRL 0 state changed.......................p1->p2 BOARD CTRL 0 state changed.......................p2->p3