No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Advanced O&M Command Reference
OceanStor 2800 V5 V500R007

This document is applicable to OceanStor 2800 V5. Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
sys showdirtydataflag

sys showdirtydataflag


The sys showdirtydataflag command is used to check the dirty data flags on the node where the engine resides.


sys showdirtydataflag




Diagnostic view

Usage Guidelines

Run this command in debug mode in developer view.


Check the dirty data flags on the node where the engine resides.

admin:/diagnose>sys showdirtydataflag
Dirty data flag value:
frame sn:2377900751982385332
serial num:24
node bitmap:3 

System Response

The following table describes the parameter meanings.



Dirty data flag value

Dirty data flags.


Magic number.

frame sn

Controller enclosure SN.

serial num

Serial number.

node bitmap

Node bitmap.

Updated: 2020-03-19

Document ID: EDOC1000181575

Views: 784469

Downloads: 37

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next