Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change chunk configuration
Function
The change chunk configuration command is used to set the threshold number of bad chunks when a disk must be isolated.
Parameters
Parameter |
Description |
Value |
---|---|---|
threshold=? | Threshold number of bad chunks. | The value ranges between "0" and "255". |
Example
To set the threshold number of bad chunks when a disk must be isolated, run the following command:
developer:/>change chunk configuration threshold=3 WARNING: You are going to adjust the upper limit for the number of isolated chunks. If the number of isolated chunks on a disk exceeds the set value, the disk is failing. Suggestion: Perform this operation based on system reliability need. Have you read warning message carefully?(y/n)y Are you sure you really want to perform the operation?(y/n)y Command executed successfully.