Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
lmr showpairctrlinfo
Function
The lmr showpairctrlinfo command is used to check the control information about a hyper mirror.
Parameters
Parameter |
Description |
Value |
|---|---|---|
| pair id | Hyper mirror ID. | To obtain the value, run the lmr getpairid lun id command on the work controller of the source LUN in the diagnose mode. |
Example
To check the control information about a hyper mirror, run the following command.
admin:/diagnose>lmr showpairctrlinfo 0 Pair Ctrl info list pairId : 0 serviceFlag : LUN_SERVICE_START bgrFlag : LUN_BGR_START self heal Time : 0 pair is data OK : FALSE bgr chunk jiffis: 0
System Response
The following table describes the parameter meanings.
Parameter |
Meaning |
|---|---|
| pairId | Volume mirror ID. |
| serviceFlag | Volume mirror starting and stopping service flag. |
| bgrFlag | Volume mirror starting and stopping BGR flag. |
| self heal Time | self-healing time. |
| pair is data OK | Data consistency. |
| bgr chunk jiffis | Copy start time. |
Previous
