Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change fdsa switch
Function
The change fdsa switch command is used to enable or disable the Fault Detecting & Self-Healing Architecture (FDSA) function. After the FDSA function is enabled, system faults are automatically detected and then healed.
Parameters
Parameter |
Description |
Value |
|---|---|---|
| switch=? | Switch of the FDSA function. |
|
Usage Guidelines
When performing operations that may cause system exceptions (for example, upgrade), disable the FDSA function so that the exceptions will not be misjudged as system faults. After these operations are completed and the system becomes stable, you can manually enable the FDSA function.
You can determine whether to enable or disable the FDSA function after checking the status of the FDSA function by executing the "show fdsa switch" command.
Example
Enable the FDSA function.
developer:/>change fdsa switch switch=yes WARNING: You are about to enable or disable the Fault Detecting & Self-Healing Architecture (FDSA) function. Suggestion:Before performing this operation, please confirm that you want to do this. Have you read warning message carefully?(y/n)y Are you sure you really want to perform the operation?(y/n)y Command executed successfully.
Previous
