No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Advanced O&M Command Reference
OceanStor 2800 V5 V500R007

This document is applicable to OceanStor 2800 V5. Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change system maintenance_ip

change system maintenance_ip


The change system maintenance_ip command is used to configure the IP address of the maintenance port on new hardware. Only IPv4 can be configured for maintenance personnel to access the disk array.


change system maintenance_ip eth_port_id=? ip=? mask=? [ gateway=? ] [ delete_gateway=? ]





eth_port_id=? Indicates the maintenance port ID.

To obtain the value, run "show port general logic_type=maintenance_port".

ip=? Indicates the IPv4 address of the maintenance port.

The IPv4 address cannot start with 0 or an integer from 224 to 255.

mask=? Indicates the subnet mask of the maintenance port.


gateway=? Indicates the gateway of the maintenance port.

The IPv4 gateway cannot start with 0 or an integer from 224 to 255.

delete_gateway=? Whether the original gateway needs to be deleted when configuring IP address for the maintenance port.

The value can be "yes" or "no", where:

  • "yes": the gateway of the port will be deleted.
  • "no": the gateway of the port will not be deleted.


Developer view

Usage Guidelines

You can only configure the IPv4 address, which is convenient for maintenance engineer to access the system.


Set the IPv4 address of the management network port on a controller to, the subnet mask to, and need to delete original gateway.

developer:/>change system maintenance_ip eth_port_id=CTE0.A.H5 ip= mask= delete_gateway=yes
WARNING: You are about to change the IP address of the maintenance port. This operation will interrupt the connection between the maintenance engineer and the system. This operation will also clear the configured routes on the IP address that is modified on this maintenance port.
Suggestion: Before you perform this operation, ensure that you have entered an available IP address.
Have you read warning message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2020-03-19

Document ID: EDOC1000181575

Views: 778540

Downloads: 37

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next