No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change user_mode current_mode

change user_mode current_mode

Function

The change user_mode current_mode command is used to switch a user view. This command is used when you want to switch from the user view to the developer or engineer view.

Format

change user_mode current_mode user_mode=?

Parameters

Parameter

Description

Value

user_mode=? View that you want to enter.

The value can be "developer" or "engineer",where:

  • "developer": developer view.
  • "engineer": engineer view.
If the error message (^) is displayed after you enter "developer" or "engineer", and press Tab or Enter, the switch to the entered view is not supported.

Level

Administrator

Usage Guidelines

None

Example

  • Enter the developer view.

    admin:/>change user_mode current_mode user_mode=developer
    DANGER: You are about to switch to the developer view. Commands in this view must be run under the guidance of R&D engineers. You can choose whether to run this command. If you run this command to switch to the developer view, it means that you know risks of running commands in the developer view. Device vendors are not responsible for any loss or damage caused to the user or others by running commands in the developer view.
    1. Running the command in the developer view may cause system reset, restart, offline, service interruption, data loss, and data inconsistency.
    2. Running the command in the developer view may cause the performance to decrease.
    3. Running the command in the developer view to delete or remove configurations may have impact on the service and data.
    4. Running the command in the developer view may cause system alarms.
    Suggestion: Run this command under the guidance of R&D engineers.
    Have you read danger alert message carefully?(y/n)y
    Are you sure you really want to perform the operation?(y/n)y
    developer:/>
  • Enter the engineer view.

    admin:/>change user_mode current_mode user_mode=engineer 
    engineer:/>

System Response

None

Translation
Download
Updated: 2020-01-17

Document ID: EDOC1000181601

Views: 382872

Downloads: 56

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next