No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Command Reference
OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
create hypervault general

create hypervault general


The create hypervault general command is used to create a HyperVault pair.


create hypervault general local_fs_id=? [ remote_device_id=? remote_fs_id=? ] [ recover_policy=? ] [ backup_rate=? ] [ restore_rate=? ] [ start_backup_after_create=? ] [ compress_enable=? ]





local_fs_id=? ID of the local file system.

To obtain the value, run the "show file_system general" command without parameters.

remote_device_id=? ID of the remote device.

To obtain the value, run "show remote_device general".

remote_fs_id=? ID of the remote file system.

To obtain the value, run the "show file_system general" command without parameters on the remote device.

recover_policy=? Fault rectification policy.

The value is "automatic" or "manual", where:

  • "automatic": Backup is automatically recovered after the interrupted link is recovered. Data is automatically backed up from the primary device.
  • "manual": After the interrupted link is recovered, you need to manually recover backup. Data will not be automatically backed up from the primary device to the secondary device.
The default value is "automatic".
backup_rate=? Backup rate.

The value is "low", "middle", "high", or "highest", where:

  • "low": low backup rate.
  • "middle": medium backup rate.
  • "high": high backup rate.
  • "highest": highest backup rate.
The default value is "middle".
restore_rate=? Restoration rate.

The value is "high" or "highest", where:

  • "high": high restoration rate.
  • "highest": highest restoration rate.
The default value is "high".
start_backup_after_create=? Whether to immediately start backup after a remote backup task is created.

The value is "yes" or "no", where:

  • "yes": starts initial backup.
  • "no": not start initial backup.
The default value is "yes".
compress_enable Whether to enable compression.

The value can be "yes" or "no", where:

  • yes: enables compression.
  • no: disables compression.



Usage Guidelines



Create a HyperVault pair. The local file system ID is "0", remote device ID is "0", and remote file system ID is "1".

admin:/>create hypervault general local_fs_id=0 remote_device_id=0 remote_fs_id=1 
Command executed successfully.

System Response


Updated: 2020-03-19

Document ID: EDOC1000181601

Views: 406325

Downloads: 56

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next