No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
create on_access_scan general

create on_access_scan general


The create on_access_scan general command is used to create the On-Access scanning function for a specified file system.


create on_access_scan general file_system_id=? file_system_name=? scan_policy_id=? [ scan_enabled=? ]





file_system_id=? File system ID.

To obtain the value, run the "show file_system general" command.

file_system_name=? File system name.

To obtain the value, run the "show file_system general" command.

scan_policy_id=? Scanning policy ID.

To obtain the value, run the "show antivirus_scan policy" command.

scan_enabled=? Switch of On-Access scanning.

Possible values are "yes" and "no", where:

  • "yes": to enable On-Access scanning.
  • "no": to disable On-Access scanning.



Usage Guidelines

  • Before running this command, ensure that the system is running correctly.
  • Before running this command, ensure that the Anti-Virus module is running correctly.


Set the scanning policy for the file system whose ID is "0" and name is "fs01" to On-Access scanning where the scanning policy ID is "0" and the switch is set to "no".

admin:/>create on_access_scan general file_system_id=0 file_system_name=fs01 scan_policy_id=0 scan_enabled=no
Command executed successfully.

System Response


Updated: 2020-01-17

Document ID: EDOC1000181601

Views: 378509

Downloads: 49

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next