No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
create fs_snapshot general

create fs_snapshot general


The create fs_snapshot general command is used to create a snapshot.


create fs_snapshot general name=? file_system_id_list=?





name=? Indicates the name of the snapshot you want to create.

The value consists of 1 to 127 ASCII characters including letters, numbers, and underscores (_).

file_system_id_list=? Indicates the ID of the file system for which you want to create a read-only snapshot.

To obtain the value, run "show file_system general".

You can specify multiple file system IDs separated by commas (,), or ID range separated by hyphens(-), such as: 0,5-8.



Usage Guidelines

  • Before performing this command, check whether the ID of the file system for which you want to create a snapshot is correct.
  • Before performing this command, check whether the name of the snapshot you want to create exists and is correct.
  • Multiple file systems can create a snapshot with the same name. Separate the IDs of the file systems with comma (,).


To create snapshot snap1, run the following command:

admin:/>create fs_snapshot general name=snap1 file_system_id_list=0
Create snapshot of file system 0 successfully.

System Response


Updated: 2020-01-17

Document ID: EDOC1000181601

Views: 378160

Downloads: 49

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next