No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI provided by DeviceManager, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change hyper_metro_vstore_pair start

change hyper_metro_vstore_pair start


The change hyper_metro_vstore_pair start command is used to forcibly start a HyperMetro vStore pair.


change hyper_metro_vstore_pair start pair_id=?






ID of the HyperMetro vStore pair.

Run the "show hyper_metro_vstore_pair general" command to obtain the value.



Usage Guidelines



To forcibly start HyperMetro vStore pair "1", run the following command.

admin:/>change hyper_metro_vstore_pair start pair_id=1 
DANGER: You are going to forcibly enable host access for local storage resource services of all member pairs in the HyperMetro vstore pair. 
Before performing this operation, ensure that host access at the remote site is stopped. Otherwise, data loss may occur. 
Suggestion: Before performing this operation, disconnect the storage array at the remote site from hosts. 
Have you read danger alert message carefully?(y/n)y 
Are you sure you really want to perform the operation?(y/n)y 
Command executed successfully.

System Response


Updated: 2019-09-02

Document ID: EDOC1000181601

Views: 329198

Downloads: 41

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next