No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change clone restore

change clone restore


The change clone restore command is used to reversely synchronize existing secondary logical unit numbers (LUNs) for a clone task.


change clone restore clone_id=? lun_id=?





clone_id=? ID of a clone task for which you want to perform reverse synchronization.

To obtain the value, run "show clone general".

lun_id=? ID of a secondary LUN.

To obtain the value, run "show clone secondary_lun".



Usage Guidelines

  • For a clone task, performing this operation overwrites the data of the primary LUN using that of the selected secondary LUN. Before performing this operation, stop all host services. Resume host services after reverse synchronization have been started.
  • Before performing this operation, ensure that the selected source LUN has been backed up and that the data of the LUN is safe to be overwritten.
  • Each clone pair supports the primary LUN to be reversely synchronized with one secondary LUN. This means that other secondary LUNs except the selected one must be split from the primary LUN.


Reversely synchronize secondary LUN "9" for clone task "3".

admin:/>change clone restore clone_id=3 lun_id=9
DANGER: You are about to reversely synchronize a secondary LUN in clone. This operation will copy the data on secondary LUN to primary LUN to overwrite the original data on primary LUN.
Suggestion: Before performing this operation:
1. Ensure that data on the primary LUN has been backed up, and I/O requests to the primary LUN have been suspended.
2. Ensure that the data on primary LUN can be overwritten.
3. During the reverse synchronization, the secondary LUN can be read only, host services on the secondary LUN will be stopped.
4. Ensure that you have selected correct primary LUN and secondary LUN to avoid misoperations.
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2020-01-17

Document ID: EDOC1000181601

Views: 382446

Downloads: 56

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next