No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
remove port ipv4_address

remove port ipv4_address

Function

The remove port ipv4_address command is used to remove the IPv4 address of a specific port.
After the IP address of an Ethernet host port is removed, the application sever that connects to the Ethernet host port cannot access the storage system.

Format

remove port ipv4_address eth_port_id=?

Parameters

Parameter

Description

Value

eth_port_id=? ID of a port.

To obtain the value, run "show port general".

Level

Administrator

Usage Guidelines

None

Example

To remove the IPv4 address of the Ethernet host port whose ID is "ENG0.A3.P0", run the following command. The ID and output vary depending on a specific product.

admin:/>remove port ipv4_address eth_port_id=ENG0.A3.P0
DANGER: You are about to clear IP addresses on port. This operation will disconnect the storage system from hosts.
Suggestion: Check whether there are redundant connections to hosts. If there are no redundant connections, stop host services.
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response

None

Translation
Download
Updated: 2020-01-17

Document ID: EDOC1000181601

Views: 381320

Downloads: 56

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next