No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
create bond_port

create bond_port


The create bond_port command is used to create an Ethernet bond port. By bonding multiple Ethernet ports, you can increase the data transmission bandwidth in parallel mode.


create bond_port iscsi_port_id_list=? [ name=? ]





iscsi_port_id_list=? List of port IDs that you want to bond.
  • To obtain the value, run "show port general".
  • Separate the port IDs that you want to bond with commas (,).
name=? Name of the Ethernet bond port you want to create.

The value contains 1 to 31 ASCII characters including digits, letters, underscores (_), hyphens (-), and periods (.).



Usage Guidelines

  • Running this command interrupts the connections of all Ethernet ports involved in the port bonding. In addition, these Ethernet ports' IP addresses and route settings will be lost, and the bond port will be used to carry services.
  • Before running this command, stop services carried by all Ethernet ports.
  • An Ethernet ports can be bonded only once.


To create an ethernet bond port, where IDs of the ports to be bond are "ENG0.B1.P0" and "ENG0.B1.P1", and the name of the bond port is "newbond", run the following command. The ID and output vary depending on a specific product.

admin:/>create bond_port iscsi_port_id_list=ENG0.B1.P0,ENG0.B1.P1 name=newbond
DANGER:You are about to bond Ethernet ports.
This operation will disconnect all links to the Ethernet port, and the IP address and route configurations will be lost. Services are switched to the newly bonded port. The mode of all switch ports connected to the Ethernet port must be configured to 802.3AD LACP.
1. Before performing this operation, stop all services on the Ethernet port.
2. Configure the mode of all switch ports connected to the Ethernet port to 802.3AD LACP.
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)
Command executed successfully.

System Response


Updated: 2020-01-17

Document ID: EDOC1000181601

Views: 382633

Downloads: 56

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next