No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change controller smartport_work_mode

change controller smartport_work_mode

Function

The change controller smartport_work_mode command is used to modify the work mode of the SmartIO ports on a specific controller.

Format

change controller smartport_work_mode controller=? mode=?

Parameters

Parameter

Description

Value

controller=? Controller ID.

To obtain the value, run "show controller general" without parameter.

mode=? Work mode of SmartIO ports.

The value can be "FC" or "FCoE/iSCSI", where:

  • "FC": indicates that SmartIO ports on a controller are working in FC mode.
  • "FCoE/iSCSI": indicates that SmartIO ports on a controller are working in FCoE/iSCSI mode.

Level

Administrator

Usage Guidelines

  • Before performing this operation, ensure that the services of all SmartIO ports on the controller are stopped.
  • After performing this operation, create a new network based on the current work mode of the SmartIO ports on the controller.
  • OceanStor 18500 V5, 18500F V5, 18800 V5 and 18800F V5 storage systems support this command.

Example

Change the work mode of the SmartIO ports on controller "0A" to "FC".

admin:/>change controller smartport_work_mode controller=0A mode=FC
DANGER:You are about to modify the work mode of the smart ports on the controller.This operation will interrupt the services of all smart ports on the controller.
Suggestion:1. Before you perform this operation, ensure that the services of all smart ports on the controller are stopped.2. After performing this operation, create a new network based on the current work mode of the smart ports on the controller.
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response

None

Translation
Download
Updated: 2020-01-17

Document ID: EDOC1000181601

Views: 383139

Downloads: 56

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next