No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
Command Reference
OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
swap dr_star

swap dr_star

Function

The swap dr_star command is used to switch DR Star.

Format

swap dr_star dr_star_id=?

Parameters

Parameter

Description

Value

dr_star_id DR Star ID.

To obtain the value, run "show dr_star general".

Level

Administrator

Usage Guidelines

  • This operation switches the states of DR Star's two asynchronous remote replication members. After the operation, the asynchronous replication not in the "Standby" state is changed to the "Standby" state.
  • Before performing a switchover, ensure that there is an asynchronous remote replication member in the "Standby" state and the two remote replication members at a site have the same primary and secondary attributes.
  • DR Star cannot be switched if its running status is "Invalid" or "Disable".

Example

Switch DR Star "200bc79b99520000".

admin:/>swap dr_star dr_star_id=200bc79b99520000
WARNING: You are about to switch DR Star trio.
This operation switches the status of two asynchronous remote replication members in the DR Star trio. Before performing this operation, check the standby synchronization mode of the DR Star trio. You are advised to perform the switchover in incremental synchronization mode. If the synchronization mode is full, the protection capacity at the size of a member LUN is required at the third site after the switchover. Ensure that the space of the third site is sufficient.
Suggestion: Ensure that you have selected the correct DR Star trio.
Have you read warning message carefully?(y/n)y
 
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response

None

Translation
Download
Updated: 2020-03-19

Document ID: EDOC1000181601

Views: 406331

Downloads: 56

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next