No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
add consistency_group remote_replication

add consistency_group remote_replication


The add consistency_group remote_replication command is used to add remote replication tasks to a consistency group.


add consistency_group remote_replication consistency_group_id=? remote_replication_id=?





consistency_group_id=? ID of a consistency group.

To obtain the value, run "show consistency_group general".

remote_replication_id=? ID of the remote replication tasks that you want to add to a consistency group.

To obtain the value, run "show remote_replication general".



Usage Guidelines

  • You can run this command only on the primary end for a consistency group.
  • You can add only a remote replication task that is in the normal, synchronizing or split state to a consistency group.
  • This command succeeds only when the replication mode of the remote replication task that you want to add is the same as that of the selected consistency group.
  • A synchronous consistency group can only contain synchronous instead of asynchronous remote replication tasks.
  • An asynchronous consistency group can only contain asynchronous instead of synchronous remote replication tasks.


To add remote replication task whose ID is respectively "9747215445131234" to consistency group "9747215445131264", run the following command:

admin:/>add consistency_group remote_replication consistency_group_id=9747215445131264 remote_replication_id=9747215445131234
Command executed successfully.

System Response


Updated: 2020-01-17

Document ID: EDOC1000181601

Views: 381744

Downloads: 56

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next