No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
show host traceroute

show host traceroute


The show host traceroute command is used to query information about routes between storage arrays and hosts.


show host traceroute { dest_ipv4=? | dest_ipv6=? | hostname=? } [ source_ipv4=? | source_ipv6=? ] [ controller=? ] [ package_size=? ] [ port=? ] [ queries_num=? ]





dest_ipv4=? Host IP address.

The value can be an IPv4 address.

dest_ipv6=? Host IP address.

The value can be an IPv6 address.

hostname=? Host name.

The value contains 1 to 255 characters including letters, digits, hyphens (-), underscores (_), and periods (.).

source_ipv4=? IPv4 address used by the local host to send data packets.

The value can be an IPv4 address.

source_ipv6=? IPv6 address used by the local host to send data packets.

The value can be an IPv6 address.

controller=? Controller ID.

To obtain the value, run the "show controller general" command.

package_size=? Probe packet size.

The value is an integer from 1 to 65000 bytes.

port=? UDP port number of the destination host.

The value is an integer from 0 to 65535.

queries_num=? Number of probe packets that can be sent once.

The value is an integer from 1 to 10.



Usage Guidelines



Show the route from the storage array to

admin:/>show host traceroute dest_ipv4=
traceroute information
traceroute to (, 30 hops max, 60 byte packets
1 (  13.440 ms 13.664 ms  13.337 ms
2 (  1.588 ms * *

System Response


Updated: 2020-01-17

Document ID: EDOC1000181601

Views: 377102

Downloads: 49

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next