No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change hyper_metro_consistency_group synchronize

change hyper_metro_consistency_group synchronize


The change hyper_metro_consistency_group synchronize command is used to start the synchronization of a HyperMetro consistency group.


change hyper_metro_consistency_group synchronize consistency_group_id=?





consistency_group_id=? ID of the HyperMetro consistency group.

Run the "show hyper_metro_consistency_group general" command without parameters to obtain the value.



Usage Guidelines



To start the synchronization of HyperMetro consistency 1, run the following command.

admin:/>change hyper_metro_consistency_group synchronize consistency_group_id=1
WARNING: You are about to start data synchronization. 
Once data synchronization is started, the system will synchronize data based on the synchronization direction of the consistency group and the data at the synchronized end cannot be restored. 
Suggestion: Before performing this operation, ensure that the parameters are correct to prevent data loss.
Have you read warning message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2020-01-17

Document ID: EDOC1000181601

Views: 377619

Downloads: 49

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next