No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
add hypervault remote_resource

add hypervault remote_resource


The add hypervault remote_resource command is used to add the remote backup function of HyperVault.


add hypervault remote_resource hypervault_id=? remote_device_id=? remote_fs_id=? [ recover_policy=? ] [ backup_rate=? ] [ restore_rate=? ] [ start_backup_after_create=? ] [ compress_enable=? ]





hypervault_id=? ID of the HyperVault object.

To obtain the value, run the "show hypervault general" command without parameters.

remote_device_id=? ID of the remote device.

To obtain the value, run the "show remote_device general" command.

remote_fs_id=? ID of the remote file system.

To obtain the value, run the "show file_system general" command without parameters on the remote device.

recover_policy=? Error rectifying policy.

The value is "automatic" or "manual", where:

  • "automatic": The HyperVault will automatically recover, and data will be automatically backup from the primary device to the secondary device.
  • "manual": The HyperVault needs to be recovered manually. Data will not be automatically backup from the primary device to the secondary device.
The default value is "manual".
backup_rate=? Backup rate.

The value is "low", "middle", "high", or "highest", where:

  • "low": slow backup speed.
  • "middle": medium backup speed.
  • "high": fast backup speed.
  • "highest": the fastest backup speed.
The default value is "middle".
restore_rate=? Restoration rate.

The value is "high" or "highest", where:

  • "high": fast restore speed.
  • "highest": the fastest restore speed.
The default value is "high".
start_backup_after_create=? Whether to immediately start backup after a remote replication job is created.

The value is "yes" or "no", where:

  • "yes": to start the initial backup.
  • "no": not to start the initial backup.
The default value is "yes".
compress_enable Whether to enable compress.

The value can be "yes" or "no", where:

  • yes: enables compress.
  • no: disables compress.



Usage Guidelines



Create a remote backup function for HyperVault "8675433423". The remote device ID is "0", and remote file system ID is "1".

admin:/>add hypervault remote_resource hypervault_id=8675433423  remote_device_id=0 remote_fs_id=1 
Command executed successfully.

System Response


Updated: 2020-01-17

Document ID: EDOC1000181601

Views: 382479

Downloads: 56

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next