No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Command Reference
OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change storage_pool relocation_schedule

change storage_pool relocation_schedule


The change storage_pool relocation_schedule command is used to change the relocation policy for a storage pool.


change storage_pool relocation_schedule pool_id=? relocation_type=?

change storage_pool relocation_schedule pool_id=? relocation_action=? [ duration=? ]





pool_id=? Storage pool ID.

The value is an integer ranging from 0 to 511.

To obtain the value, run "show storage_pool general".

relocation_type=? Data relocation triggering mode. If you specify this parameter, you cannot specify parameter relocation_action=?.

The value can be "automatic" or "manual", where:

  • "automatic": indicates timed relocation.
  • "manual": indicates manual relocation.
relocation_action=? Data relocation action. If you specify this parameter, you cannot specify parameter relocation_type=?.

The value can be "start", "stop", "pause", or "continue", where:

  • "start": starts data relocation.
  • "stop": stops data relocation.
  • "pause": suspends data relocation.
  • "continue": continues data relocation.
duration=? Duration of data relocation. This parameter must be specified when relocation_action=? is set to "start".

The value is in the format of HH:MM or H:M. The value ranges from 00:30 to 24:00, indicating 30 minutes to 24 hours.



Usage Guidelines

OceanStor 18500 V5, 18500 V5 Kunpeng, 18800 V5 and 18800 V5 Kunpeng storage systems support this command.


Change the data relocation triggering mode of storage pool "0" to "automatic".

admin:/>change storage_pool relocation_schedule pool_id=0 relocation_type=automatic
Command executed successfully.

System Response


Updated: 2020-03-19

Document ID: EDOC1000181601

Views: 406312

Downloads: 56

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next