No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
delete failover_group general

delete failover_group general


The delete failover_group general command is used to delete a specified customized failover group.


delete failover_group general failover_group_id=?





failover_group_id=? ID of a failover group.
  • The value is an integer between 1 and 1024.
  • To obtain the value, run the "show failover_group general" command without parameters.



Usage Guidelines

  • Run the "show failover_group general" command to view the failover group ID.
  • Run the "delete failover_group failover_group_id=?" command to delete a specified customized failover group. Only customized failover groups are supported.


Delete a specified customized failover group.

admin:/>delete failover_group general failover_group_id=1
DANGER: You are about to delete a failover group. This operation will prevent member ports in the failover group from floating in user-defined mode.
Suggestion: Before performing this operation, ensure that member ports in the failover group do not need to float in user-defined mode.
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2020-01-17

Document ID: EDOC1000181601

Views: 381746

Downloads: 56

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next