No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
add lun_copy other_vendor_target

add lun_copy other_vendor_target


The add lun_copy other_vendor_target command is used to add target logical unit numbers (LUNs) for a LUN copy, where the LUNs reside on third-party storage systems.


add lun_copy other_vendor_target lun_copy_id=? target_lun_wwn=?





lun_copy_id=? ID of a LUN copy.

To obtain the value, run "show lun_copy general".

target_lun_wwn=? World Wide Name (WWN) of a target LUN, which uniquely specifies a third-party device.

To obtain the value, run "show remote_lun general".



Usage Guidelines

  • A target LUN can not be added to a LUN Copy which is in the state of copying or pause.
  • The data of a source LUN overwrites that of a target LUN upon the start of a LUN copy task.
  • Before running this command, ensure that the selected source and target LUNs are exactly the ones you want to use for a remote LUN copy task, and that no host is accessing the target LUN.
  • Different LUN copies cannot share the same target LUN.


Add a target LUN on a third-party storage system whose WWN is "60:02:2a:11:00:0b:81:68:00:02:93:94:00:00:00:11" to LUN copy "0".

admin:/>add lun_copy other_vendor_target lun_copy_id=0 target_lun_wwn=60:02:2a:11:00:0b:81:68:00:02:93:94:00:00:00:11
WARNING: You are about to build a LUN copy relationship between source LUN and target LUN. After this operation, the data on the target LUN will be overwritten by the data on the source LUN.
Suggestion: Before performing this operation, ensure that the selected source and target LUNs are correct, and the target LUN is not being read or written by hosts.
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2020-01-17

Document ID: EDOC1000181601

Views: 376876

Downloads: 49

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next