No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Command Reference
OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5 storage systems. It describes hardware installation of those storage systems for helping you easily and quickly finish the installation.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change sso general

change sso general


The change sso general command is used to modify the single sign-on (SSO) configuration.


change sso general switch=? [ address=? ] [ port=? ]





switch Switch for the SSO function.

The value can be "on" or "off", where:

  • "on": enables the SSO function.
  • "off": disables the SSO function.
address IP address of the SSO server.

The value can be a domain name or an IP address (IPv4 or IPv6). A domain name contains 1 to 255 characters including letters (case insensitive), digits, and hyphens (-). Domain names at different levels are separated by periods (.). A domain name cannot start or end with a hyphen (-).

port Port of the SSO server.

The value is an integer from 1 to 65535.


Super administrator

Usage Guidelines

After the command is executed successfully, the system modifies the SSO configuration based on command parameters.


  • Enable the SSO server whose IP address is "" and port number is "31943" for the system.

    admin:/>change sso general switch=on address= port=31943
    Command executed successfully.
  • Disable the SSO function for the system.

    admin:/>change sso general switch=off
    Command executed successfully.

System Response


Updated: 2020-03-19

Document ID: EDOC1000181601

Views: 406257

Downloads: 56

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next