No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI provided by DeviceManager, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
create hyper_metro_consistency_group general

create hyper_metro_consistency_group general


The create hyper_metro_consistency_group general command is used to create a HyperMetro consistency group.


create hyper_metro_consistency_group general domain_id=? name=? [ description=? | recovery_policy=? | synchronization_rate=? ]






ID of the HyperMetro domain.

Run the "show hyper_metro_domain general" command without parameters to obtain the value.


Name of the consistency group.

The value contains 1 to 31 ASCII characters including digits, letters, underscores (_), hyphens (-), and periods (.), and can only start with a digit or a letter.


Description of the HyperMetro consistency group.

The value contains 1 to 127 letters.


Recovery policy.

The value is "automatic" or "manual", where:

  • "automatic": automatic recovery policy. Data will be automatically synchronized after faults are rectified.
  • "manual": manual recovery policy. Data needs to be manually synchronized after faults are rectified.

The default value is "automatic".


Synchronization rate.

The value is "Low", "Middle", "High", or "Highest", where:

  • "Low": low rate.
  • "Middle": medium rate.
  • "High": high rate.
  • "Highest": the highest rate.

The default value is "Middle".



Usage Guidelines



  • Create a HyperMetro consistency group.
    admin:/>create hyper_metro_consistency_group general domain_id=1 name=xx  
    Command executed successfully. 
  • Create a HyperMetro consistency group.
    admin:/>create hyper_metro_consistency_group general domain_id=1 name=xx synchronization_rate=Highest 
    WARNING: You are about to select the "Highest" speed to create a HyperMetro consistency group. 
    After the operation, HyperMetro pairs in the consistency group will be synchronized at the highest speed, which may cause overloaded services and disconnection of HyperMetro pairs. 
    Suggestion: Select the "High" speed. If you select the "Highest" speed, check the performance of the data receiving end and whether the link bandwidth between local and remote arrays is sufficient to prevent the disconnection of HyperMetro pairs during synchronization. 
    Have you read warning message carefully?(y/n)y 
    Are you sure you really want to perform the operation?(y/n)y 
    Command executed successfully.

System Response


Updated: 2019-09-02

Document ID: EDOC1000181601

Views: 327892

Downloads: 41

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next