No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
restore configuration_data

restore configuration_data


The restore configuration_data command is used to restore database data in a disk backup partition.


restore configuration_data




Developer view

Usage Guidelines

  • This command provides an interactive mode for entering passwords. The password will be displayed behind asterisks.
  • If the number of consecutively entered incorrect passwords reaches 3 within 5 minutes, the current session will be disconnected.


To restore database data in a disk backup partition, run the following command.

developer:/>restore configuration_data
DANGER: You are going to restore the configuration data from the backup area of the coffer disk. This operation causes the storage system to restart automatically. All running services on the storage system are interrupted.
Suggestion: Before you perform this operation, implement the following steps:
1. Check whether the model, version, and time of the configuration data in the backup area are correct.
2. Back up the existing configuration data.
3. Stop all running services on the system.
4. This command restores only the database configuration data. If storage services are modified after backing up the database configuration data, do not attempt to recover the database configuration data from the backup area. Otherwise, storage services may fail and the storage system may fail to be started up.
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2020-01-17

Document ID: EDOC1000181602

Views: 765698

Downloads: 66

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next