No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change port eth_toe_switch

change port eth_toe_switch


The change port eth_toe_switch command is used to enable/disable the TOE function of an Ethernet port.


change port eth_toe_switch eth_port_id=? toe_enable=?






ID of a port.

To obtain the value, run "show port general".


Switch status of the TOE function.

The value can be "yes" or "no", where:

  • "yes": Indicates the TOE function is enabled.
  • "no": Indicates the TOE function is disabled.


Developer view

Usage Guidelines

Before performing this operation, ensure that the Ethernet port supports the TOE function.


Enable/Disable the TOE function of Ethernet port "CTE0.A.H0". The ID and command output vary depending on products. The ID and output here are just examples.

developer:/>change port eth_toe_switch eth_port_id=CTE.A.H0 toe_enable=yes 
CAUTION: You are about to enable/disable the TOE function of an Ethernet port. 
This function can only be valid on the TCP connection that is established after the configuration is modified. The established TCP connection continues to run according to the original configuration. 
Do you wish to continue?(y/n)y 
Command executed successfully. 

System Response


Updated: 2019-07-11

Document ID: EDOC1000181602

Views: 629431

Downloads: 55

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next