No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
switch

switch

Function

The switch command is used to switch serial ports.

Format

switch type

Parameters

Parameter

Description

Value

type

Switchover type.

The value is "0" and "1", or "a", "b", and "c", where:

  • "0": switches to the SES serial port from the operating system serial port. A hexadecimal value is also supported.
NOTE:

This parameter is only valid in devices integrating disks and controllers.]

  • "1": switches to the operating system serial port. A hexadecimal value is also supported. [Note:This parameter is only valid in devices integrating disks and controllers.]
  • "a": switches to A SES serial port of the high-density disk enclosure. [Note:This parameter is only valid in high-density disk enclosures.]
  • "b": switches to B SES serial port of the high-density disk enclosure. [Note:This parameter is only valid in high-density disk enclosures.]
  • "c": switches to C SES serial port of the high-density disk enclosure. [Note:This parameter is only valid in high-density disk enclosures.

Modes

serial port mode

Usage Guidelines

This command is only supported in controller-and-disk integrated controller enclosures or high-density disk enclosures.

Example

Run the "switch 0" command to switch the serial port to the SES system serial port.

PANGEA_SES:> switch 0

System Response

None

Translation
Download
Updated: 2019-07-11

Document ID: EDOC1000181602

Views: 632271

Downloads: 56

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next