No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
add shake_alarm general

add shake_alarm general


The add shake_alarm general command is used to add the alarm that needs to be cached before it is reported.


add shake_alarm general alarm_id=? interval=?





alarm_id=? Alarm ID.

The value is the hexadecimal ID of a valid alarm whose severity is WARNING, MAJOR, or CRITICAL.

interval=? Cache interval.

The value is an integer between 0 and 604800 seconds.


Developer view

Usage Guidelines

  • The alarm ID must be valid, and the ID is in hexadecimal format.
  • The cache interval ranges from 0 to 604800 seconds.


Add the alarm that needs to be cached before it is reported.

developer:/>add shake_alarm general alarm_id=0xF0C90001 interval=10
WARNING: You are about to cache the alarm before reporting it. This operation causes the alarm to be reported after it is cached. If this alarm is generated, the alarm is cached according to the time that you set. This causes the alarm to fail to be reported immediately. During alarm cache, if this alarm is recovered, this alarm will not be reported.
Suggestion: Before performing this operation, ensure that this alarm needs to be cached before it is reported, and the cache interval that you set is reasonable.
Have you read warning message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response

The following table describes the parameter meanings.



Alarm ID

Alarm ID.


Cache interval.

Updated: 2020-01-17

Document ID: EDOC1000181602

Views: 765681

Downloads: 66

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next