No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
show space apo_entry_info

show space apo_entry_info


The show space apo_entry_info command is used to query an entry from a specified APO object.


show space apo_entry_info object_set_id=? object_id=? name=? controller=?





object_set_id=? Indicates the object set ID.

The value is the sum of the file system ID and the base object set ID. The base object set ID of the file system is "0x4000000000" (in hexadecimal) = "274877906944" (in decimal). The MOS base object set ID is "0x2000000000" (in hexadecimal) = "137438953472" (in decimal). The DCL base object set ID is "0x5000000000" (in hexadecimal) = "343597383680" (in decimal). For example, if the file system ID is "20", the object set ID of the file system = "0x4000000000" + "20".

object_id=? Indicates the object ID.

The value must be greater than "0", and smaller than "2305843009213693952".

name=? Indicates the entry name.

The value can contain letters, digits, underscores ("_"), and special characters that can be used in file names.

controller=? Indicates the controller ID.

The value is in the format of "XA" or "XB" or "XC" or "XD", where the "X" is an integer ranging from 0 to 3, for example: "0A", "1C".


Developer view

Usage Guidelines



To query the entry which key is "qtree" in the object "3" of the object set "274877906944", run the following command.

developer:/>show space apo_entry_info object_set_id=274877906944 object_id=3 name=qtree controller=0A
  Key   : qtree                                    
  Value : 4001

System Response

The following table describes the parameter meanings.




Indicates key of the entry.


Indicates value of the entry.

Updated: 2020-01-17

Document ID: EDOC1000181602

Views: 744647

Downloads: 59

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next