No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
menu

menu

Function

The menu command is used to display all the supported commands in serial port mode.

Format

menu

Parameters

None

Modes

serial port mode

Usage Guidelines

  • After you run this command, all the available commands in serial port mode will be displayed.
  • The available command sets in the serial port mode vary with different types of storage devices. That is, if you run this command on different storage systems, the available command sets that are displayed will be different.

Example

Run the "menu" command to display all commands supported by controller-and-disk integrated devices in serial port mode.

PANGEA_SES:>menu
ai          query alarm info : ai
allalarm    get all alarm info : allalarm
bbu         read bbu info    : bbu<index>
bootfromnet   set operation system booting from network  :bootfromnet <>
dq          disable query    : dq
fwdl        download SES or CPLD image : fwdl
getkerlog   print eeprom log : getkerlog
gf          print ses flag   : gf
is          print i2c state, 00 is ok : is
menu        Menu of commands
overtime    set time limit
phyctl      phy enable/disable: phyctl <1-enable,0-disable><log_phyid>
qerr        query err cnt    : qerr
qlog        show ses log     : qlog <type>
reboot      reset through cpld wdg : reboot
rebootsystem   reboot local operation system from cpld  :rebootsystem <type id>
reset       Reset device
rfru        read fru info    : fru <type  id>
rsensor     read sensor info : rsensor <id>
showcpld    get all cpld info:allcpld
showdisk    query disk status: showdisk
showfan     read fan info    : showfan <fan index>
showphy     query phy status : showphy
showpower   read power info  : showpower <power index>
showversion  query version and hardware info : info
switch      display the  info of com : com

System Response

None

Translation
Download
Updated: 2020-01-17

Document ID: EDOC1000181602

Views: 761149

Downloads: 66

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next