No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
drvist showmgmt

drvist showmgmt


The drvist showmgmt command is used to view statistics on the task management commands of iSCSI targets.


drvist showmgmt




Diagnostic view

Usage Guidelines



View statistics on the task management commands of iSCSI targets.

admin:/diagnose>drvist showmgmt
Show iscsi management cmd statistic
Cmd type           Begin    Good rsp  Bad rsp  
Invalid            0        0         0        
Abort task         0        0         0        
Abort task set     0        0         0        
Clean aca          0        0         0        
Clean task set     0        0         0        
Logical unit reset 0        0         0        
Target warm reset  0        0         0        
Target cold reset  0        0         0        
Task reassign      0        0         0  

System Response

The following table describes the parameter meanings.




Statistics on invalid commands.

Abort task

Statistics on abort commands.

Abort task set

Statistics on abort task set commands.

Clean aca

Statistics on clean aca commands.

Clean task set

Statistics on clean task set commands.

Logical unit reset

Statistics on LUN reset commands.

Target warm reset

Statistics on warm reset commands.

Target cold reset

Statistics on cold reset commands.

Task reassign

Statistics on task reassign commands.

Updated: 2020-01-17

Document ID: EDOC1000181602

Views: 761025

Downloads: 66

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next