No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change disk_domain disklog_repair

change disk_domain disklog_repair


The change disk_domain disklog_repair command is used to configure parameters for the disk log repair function.


change disk_domain disklog_repair disk_domain_id=? switch=?





disk_domain_id=? Disk domain ID.

To obtain the value, run the "show disk_domain general" command in guest view.

switch=? Status of the disk log repair function.

The value can be "on" or "off":

  • "on": the disk log repair function will be enabled.
  • "off": the disk log repair function will not be enabled.


Developer view

Usage Guidelines



Enable the disk log repair function for disk domains.

developer:/>change disk_domain disklog_repair disk_domain_id=0 switch=on
CAUTION:You are about to enable or disable the disk log repair function. 
After the disk log repair function is enabled, repairing some disk domains may automatically repair disk logs.
After this function is disabled, the disk log repair function becomes unavailable.
Suggestion: Before performing this operation, ensure that the disk log repair function needs to be enabled or disabled.
Do you wish to continue?(y/n)y
Command executed successfully.

System Response


Updated: 2020-01-17

Document ID: EDOC1000181602

Views: 763665

Downloads: 66

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next