No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).


The command is used to modify the TracePoint configuration file.

Format { -a | -d } -f func -t type -i alive -p param





-a | -d To add or delete TracePoint configurations.

The value is -a or -d:

  • -a: to add TracePoint configurations.
  • -d: to delete TracePoint configurations.
-f func TracePoint registering name.


-t type TracePoint activation type.

The value is callback, reset, or pause.

  • callback: After TracePoint is activated, the registered callback function is invoked.
  • reset: After TracePoint is activated, the system resets.
  • pause: After TracePoint is activated, the process suspends at TracePoint.
-i alive Number of times that TracePoint is executed after being activated.

The value is an integer between 0 and 9.

-p param User parameter.



Minisystem mode

Usage Guidelines

If you need to activate a failed point when you are powering on the device or when the automation test is in progress, you need to activate it through the configuration file. Note that the TracePoint in the configuration file must be realized.


To modify the TracePoint configuration file, run the following command.

Storage: minisystem> -a -f CR_DCL_2_203_2 -t callback -i 0 -p aaaaa

System Response


Updated: 2020-01-17

Document ID: EDOC1000181602

Views: 765861

Downloads: 66

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next