show fdsa switch
Function
The show fdsa switch command is used to check whether the Fault Detecting & Self-Healing Architecture (FDSA) function is enabled. After the FDSA function is enabled, system faults are detected automatically and then healed.
Format
show fdsa switch
Parameters
None
Views
Developer view
Usage Guidelines
When performing operations that may cause system exceptions, for example, upgrade, disable the FDSA function so that the exceptions will not be misjudged as system faults. After these operations are completed and the system becomes stable,
you can manually enable the FDSA function.
You can determine whether to enable or disable the FDSA function after checking the status of the FDSA function.
Example
Check whether the FDSA function is enabled.
developer:/>show fdsa switch
Switch : On
System Response
The following table describes the parameter meanings.
Parameter |
Meaning |
|---|---|
Switch |
Status of the switch. |
Previous
