No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Advanced O&M Command Reference
OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change full_copy job_information

change full_copy job_information


The change full_copy job_information command is used to configure the parameters for executing the full copy command.


change full_copy job_infomation concurrent_value=? speed=?





concurrent_value=? Maximum concurrency for executing the command.

The value ranges from 1 to 128. The default value is 128.

speed=? Speed at which the command is executed.

The value can be "low", "middle", "high", or "highest".


Developer view

Usage Guidelines

This command is used to configure the speed limit of full copy. If you want to cancel the limit on the full copy command, run the "change full_copy job_information concurrent_value=128 speed=highest" command to set the parameter values to default values.


Set the concurrent value to 128 and speed to highest, run the following command.

developer:/>change full_copy job_information concurrent_value=128 speed=highest
WARNING: You are about to configure the parameters for executing the full copy command. This operation will affect the performance of services related to the full copy.
Have you read warning message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2020-03-19

Document ID: EDOC1000181602

Views: 846949

Downloads: 66

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next