No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Advanced O&M Command Reference
OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
reboot expansion_module

reboot expansion_module


The reboot expansion_module command is used to reset specific expansion modules.


reboot expansion_module expansion_module_id=?





expansion_module_id=? Expansion module ID.

To obtain the value, run "show expansion_module". The value contains 1 to 31 characters, including letters, digits, and periods (.). The value cannot start with a digit or a period (.), or end with a period (.).


Developer view

Usage Guidelines

  • Run show expansion_module to query information about all the expansion modules.
  • Run reboot expansion_module expansion_module_id=? to reset a specific expansion module.
  • The expansion module is reset one minute after the command is executed.


Resetting expansion module "DAE030.A".

developer:/>reboot expansion_module expansion_module_id=DAE030.A
DANGER: You are about to reboot the expansion module. This operation causes the performance fluctuation of some disks or service termination.
Suggestion: Before performing this operation, stop services running on the service ports of the controller to which the expansion module belongs. You are strongly advised not to reboot the expansion module when the expansion module is working correctly.
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2020-03-19

Document ID: EDOC1000181602

Views: 836008

Downloads: 66

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next