No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
spa queryext

spa queryext


The spa queryext command is used to query information about a single extent.


spa queryext -p pool id -l lun id -e extent id -t volume type





pool id Disk domain ID.

The ID can be obtained by running the show disk_domain general command in super administrator mode.

lun id LUN ID.

The value ranges from 0 to n minus one. n indicates the maximum number of LUNs.

extent id Extent ID.


volume type Volume type.

The value can be 0 or 1.

  • 0: data.
  • 1: meta.


Diagnostic view

Usage Guidelines

This command must be run on the working controller of the LUN.


Query the information of extent 0x40000001 of LUN 0 in disk pool 0, and volume type is meta.

admin:/diagnose>spa queryext -p 0 -l 0 -e 0x40000001 -t 1
Extent ID : 0x40000001
Ckg ID : 0x4000
Ckg Offset : 1
Init Flag : 1 (0:init not finished 1: init finished)
Zone Index : 0
Migrate Flag : 0 (0:not migrate 1:migrate)

System Response

The following table describes the parameter meanings.



Extent ID

Extent ID.

Ckg ID


Ckg Offset

Offset in a CKG.

Init Flag

Whether the extent is initialized. 0 indicates the extent is not initialized. 1 indicates the extent is initialized.

Updated: 2020-01-17

Document ID: EDOC1000181602

Views: 750363

Downloads: 64

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next