No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change remote_replication rollback_status_stop

change remote_replication rollback_status_stop


The change remote_replication rollback_status_stop command is used to disable the rollback of a remote replication.


change remote_replication rollback_status_stop remote_replication_id=?





remote_replication_id=? Remote replication ID

To obtain the value, run the show remote_replication general command without parameters.


Developer view

Usage Guidelines

  • You should use this command when a rollback fails and you need to disable it.
  • This command can be executed on a slave end and can only be used under the guidance of a maintenance engineer.


To disable the rollback of remote replication 0, run the following command:

developer:/>change remote_replication rollback_status_stop remote_replication_id=0
DANGER:You are about to stop rolling back remote replication 0.
This operation will stop rolling back data on the secondary LUN, and the data may become unavailable. If the rollback is canceled, it cannot be initiated again.
Suggestion: Ensure that you have selected the correct remote replication before performing this operation.
   Have you read danger alert carefully?(y/n)Y
   Are you sure you really want to perform the operation?(y/n)Y
   Command executed successfully.

System Response


Updated: 2020-01-17

Document ID: EDOC1000181602

Views: 756824

Downloads: 66

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next