No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
show lun repair_info

show lun repair_info


The show lun repair_info command is used to query LUN repair.


show lun repair_info disk_domain_id=? lun_id=? action=?





disk_domain_id=? Disk domain ID.

To obtain the value, run the "show disk_domain general" command in guest view.

lun_id=? LUN ID.

To obtain the value, run the "show lun general" command in guest view.

action=? 0peration.

The value can be "repair"or "repair_reclaim", where:

  • "repair": to repair the LUN.
  • "repair_reclaim": to reclaim idle Extents on the LUN.


Developer view

Usage Guidelines



To check the repair status of LUN 5 in disk domain 2, run the following command.

developer:/>show lun repair_info disk_domain_id=2 lun_id=5 action=repair
  Operate Type        : repair            
  Repair Method       : --                
  Total Step          : 7                 
  Current Step        : 7.Finishing repair 
  Result              : Success.          
  Remaining Time(min) : 0                 

System Response

The following table describes the parameter meanings.



Operate Type

Operation type.

Repair Method

The method of repairing.

Total Step

Total steps of the operation.

Current Step

Step in progress.


Execution result.

Remaining Time(min)

Expected remaining time of the current step.

Updated: 2020-01-17

Document ID: EDOC1000181602

Views: 761126

Downloads: 66

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next