No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
show fs_snap_control code

show fs_snap_control code


The show fs_snap_control code command is used to view command execution records of a specific snapshot operation of a specific file system.


show fs_snap_control code file_system_id=? command_type=? controller=?





file_system_id=? File system ID.

To obtain the value, run the "show file_system general" command.

command_type=? Command type.

The value can be "get", "create", "count", "batch", "auto_create", "auto_delete", "modify", "delete", or "roll_back", where:

  • "get": indicates the query command.
  • "create": indicates the creation command.
  • "count": indicates the count command.
  • "batch": indicates the batch query command.
  • "auto_create": indicates the automatic creation command.
  • "auto_delete": indicates the automatic deletion command.
  • "modify": indicates the modification command.
  • "delete": indicates the deletion command.
  • "roll_back": indicates the rollback command.
controller=? ID of a controller.

To obtain the value, run "show controller general".


Developer view

Usage Guidelines

  • Before performing this operation, check whether the file system ID to be queried is correct.
  • Before performing this operation, check whether the operation type to be queried is correct.


Command execution records of a specific snapshot operation of a specific file system.

developer:/>show fs_snap_control code file_system_id=0 command_type=create controller=0A
Time Task ID Action Result 
------------------- ------- ------------------------------ ------ 
2015-04-30 01:39:59 10 CREATE TASK OK 
2015-04-30 01:39:59 10 SNAP_ACTION_FS_CREATE INIT 
2015-04-30 01:39:59 10 SNAP_ACTION_FS_CREATE OK 
2015-04-30 01:39:59 10 SNAP_ACTION_FS_CREATE_FILL_RET OK 
2015-04-30 01:39:59 10 SNAP_ACTION_FS_TASK_OVER OK 
2015-04-30 01:39:59 10 FINISH OK

System Response

The following table describes the parameter meanings.




Task end time.

Task ID

Task ID.


Task action.



Updated: 2020-01-17

Document ID: EDOC1000181602

Views: 753999

Downloads: 66

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next