Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
rootfs_cp
Function
The rootfs_cp command is used to copy the rootfs file to the flash memory.
Format
rootfs_cp
Parameters
None
Modes
serial port mode
Usage Guidelines
None
Example
Copy the rootfs file to the flash memory.
Hi1710_UBOOT> rootfs_cp
During the upgrade, ensure that the PCB is powered on and is not in the reset process, or the upgrade will fail, or even worse, the
PCB cannot work normally.
erase flash from :40200000 to :41bfffff,please wait a while
....................................................................................................................................
............................................................................ done
Erased 208 sectors
Copy root file system to flash,please wait a while
9....8....7....6....5....4....3....2....1....
erase flash from :43200000 to :44bfffff,please wait a while
....................................................................................................................................
............................................................................ done
Erased 208 sectors
Copy root file system to flash,please wait a while
9....8....7....6....5....4....3....2....1....Clean rootfs image info
Un-Protected 1 sectors
Erasing Flash...
. done
Erased 1 sectors
Writing to Flash... 9....8....7....6....5....4....3....2....1....done
Protected 1 sectors
Success to load root file system.
System Response
None
Previous
