No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 18000 and 18000F V5 Series V500R007

This document is applicable to OceanStor 18500 V5, 18800 V5, 18500F V5, and 18800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
show fs_snap_control all_task_info

show fs_snap_control all_task_info


The show fs_snap_control all_task_info command is used to view all snapshot commands executed for a specific file system or specific file system snapshot.


show fs_snap_control all_task_info file_system_id=? controller=? [ start_task_id=? ]





file_system_id=? ID of the file system to which the snapshot to be queried belongs.

To obtain the value, run the "show file_system general" command.

start_task_id=? Start task ID of the file system to which the snapshot to be queried belongs.

To obtain the value, run the "show fs_snap_control action" command.

controller=? ID of a controller.

To obtain the value, run "show controller general".


Developer view

Usage Guidelines

  • Before performing this operation, check whether the file system ID to be queried is correct.
  • Before performing this operation, check whether the task start ID to be queried is correct.


View execution status of all snapshot commands after a specific start task ID of a specific file system.

developer:/>show fs_snap_control all_task_info file_system_id=0 controller=0A start_task_id=3
Task ID Start Time End Time Type 
------- ------------------- ------------------- ----------------------- 
3 2015-04-30 01:28:08 2015-04-30 01:28:08 SNAP_CTASK_FS_GET_BATCH 
4 2015-04-30 01:31:54 2015-04-30 01:31:54 SNAP_CTASK_FS_GET_BATCH 
5 2015-04-30 01:36:26 2015-04-30 01:36:26 SNAP_CTASK_FS_GET_BATCH 
7 2015-04-30 01:37:21 2015-04-30 01:37:21 UNKNOWN 
8 2015-04-30 01:37:54 2015-04-30 01:37:54 SNAP_CTASK_FS_GET_BATCH 
9 2015-04-30 01:39:56 2015-04-30 01:39:56 UNKNOWN 
10 2015-04-30 01:39:59 2015-04-30 01:39:59 SNAP_CTASK_FS_CREATE

System Response

The following table describes the parameter meanings.



Start Time

Start time.

End Time

End time.

Task ID

Task ID.


Task type.

Updated: 2020-01-17

Document ID: EDOC1000181602

Views: 742956

Downloads: 59

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next