No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 5000, 5000F, 6000, and 6000F V5 Series V500R007

This document is applicable to OceanStor 5110 V5, 5110F V5, 5300 V5, 5500 V5, 5600 V5, 5800 V5, 6800 V5, 5300F V5, 5500F V5, 5600F V5, 5800F V5, and 6800F V5. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



The menu command is used to display all the supported commands in serial port mode.






serial port mode

Usage Guidelines

  • After you run this command, all the available commands in serial port mode will be displayed.
  • The available command sets in the serial port mode vary with different types of storage devices. That is, if you run this command on different storage systems, the available command sets that are displayed will be different.


Run the "menu" command to display all commands supported by controller-and-disk integrated devices in serial port mode.

ai          query alarm info : ai 
allalarm get all alarm info : allalarm 
bbu         read bbu info : bbu<index> 
bootfromnet set operation system booting from network  :bootfromnet <> 
dq          disable query : dq 
fwdl        download SES or CPLD image : fwdl 
getkerlog print eeprom log : getkerlog 
gf          print ses flag : gf 
is          print i2c state, 00 is ok : is 
menu      Menu of commands 
overtime set time limit 
phyctl      phy enable/disable: phyctl <1-enable,0-disable><log_phyid> 
qerr        query err cnt : qerr 
qlog        show ses log     : qlog <type> 
reboot      reset through cpld wdg : reboot 
rebootsystem reboot local operation system from cpld  :rebootsystem <type id> 
reset       Reset device 
rfru        read fru info : fru <type  id> 
rsensor     read sensor info : rsensor <id> 
showcpld get all cpld info:allcpld 
showdisk query disk status: showdisk 
showfan     read fan info : showfan <fan index> 
showphy     query phy status : showphy 
showpower read power info  : showpower <power index> 
showversion  query version and hardware info : info 
switch      display the  info of com : com

System Response


Updated: 2019-07-11

Document ID: EDOC1000181619

Views: 639413

Downloads: 256

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next